Feedstock and Spray Drying

One important advantage of spray drying is that the feedstock, or raw material, can be in virtually any form that can be pumped. Solutions, slurries, pastes, gels and suspensions can be successfully spray dried. The first step in the spray drying process is to prepare the feedstock for spraying by optimizing the temperature, concentration, viscosity or other characteristic.

Learn more about spray Drying

Spray Drying Basics
Feed stock

Feed Temperature

The temperature of the raw material affects the viscosity and the transfer of heat from the drying air in the chamber to the droplets. Both the temperature of the product and the temperature of the chamber air need to be considered when selecting nozzle seal materials.

Melting Temperature

Some feedstock is solid at room temperature and must be melted in order to atomize them. Prilling or spray cooling involves forming pellets or crystals by spraying melted product into a chamber through which cooling air is flowing.

Abrasion

The abrasiveness must be considered when selecting the material for the internal nozzle components. For most applications, tungsten carbide is the material of choice for the swirls and orifice discs. Tungsten carbide has excellent resistance to abrasion and good corrosion resistance for most raw material.

Corrosion

In some cases, a corrosive attack on the nozzle components is a greater problem then abrasion. For these cases, 316 stainless steel or Nitronic may be good choices.

Specific Gravity

The specific gravity is the density of the feedstock relative to water. A specific gravity greater than 1.0 means that the feedstock is denser than water. Increasing the specific gravity reduces the flow through a nozzle. Converting your density units to g/ml will yield the specific gravity value, since water has a density of 1 g/ml.

Solid Content

The solids content is the percent of the feedstock that is composed of solids. Usually this is about 50% in solids, although the range is from about 20% to 70%. Increasing the solids content reduces the amount of moisture removed in the spray drying process. As the solids content increases, the feedstock becomes more difficult to pump and atomize.

Surface Tension

Surface tension is the force acting on the surface of a liquid that tends to minimize its surface area. Reducing surface tension makes a feedstock easier to atomize.

Viscosity

Viscosity is the resistance to flow of fluids. The most commonly used unit is the centipoise. Increasing viscosity tends to increase droplet size. For some nozzle designs, increasing the viscosity tends to increase the flow rate.

Get in touch with Erik!

Do you have any questions regarding our Spray Drying Nozzles, Bodies & Adapters or Specialty components? Don’t hasitate to call or send an e-mail!

Picture of Erik Sanders

Erik Sanders

Sales Manager
Raca International

Raca International BV is a supplier of replacement nozzles for major brands. The product range includes spray nozzles for the production of powders, produced with high pressure nozzle atomization. All our nozzles are manufactured in our factory with the highest grades of raw material tungsten carbide.

We use cookies to give you the best online experience. By agreeing you accept the use of cookies in accordance with our cookie policy.

Close Popup
Privacy Settings saved!
Privacy Settings

When you visit any web site, it may store or retrieve information on your browser, mostly in the form of cookies. Control your personal Cookie Services here.

These cookies are necessary for the website to function and cannot be switched off in our systems.

Technical Cookies
In order to use this website we use the following technically required cookies
  • wordpress_test_cookie
  • wordpress_logged_in_
  • wordpress_sec

Decline all Services
Save
Accept all Services